Installing the M.2 2230 solid-state drive in M.2 slot one
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed in M.2 slot one.
NOTE Depending on the configuration ordered, your computer may support an M.2 2230 solid-state drive or an M.2 2280 solid-state drive in M.2 slot one.
NOTE M.2 slot two supports one PCIe Gen3 x4 NVMe or SATA solid-state drive (M.2 2230 or M.2 2280) or one Intel Optane Memory H10 with Solid State Storage.
NOTE Install the solid-state drive mounting bracket, if it is not installed.
NOTE If there is only one solid-state drive in the configuration you ordered, you can install another solid-state drive in the other M.2 slot. However, you may need a solid-state drive bracket (sold separately; please contact Dell support) to install the additional solid-state drive.
The following image indicates the location of the M.2 2230 solid-state drive that is installed in M.2 slot one and provides a visual representation of the installation procedure.
Steps
Align the notches on the solid-state drive with the M.2 slot one on the system board.
Slide the solid-state drive into the M.2 slot one on the system board.
Replace the screw (M2x3) that secures the solid-state drive to the palm-rest and keyboard assembly.