Removing the display assembly
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Peel the tape that secures the display cable to the system board.
- Open the latch, and then disconnect the display cable from the system board.
- Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
- Remove the four screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
- Lift the left and right display hinges.
- Slide the palm-rest and keyboard assembly off the display assembly.
- After performing the above steps, you are left with the display assembly.
Data is not available for the Topic