Removing the display assembly
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
![Image: Disconnecting the display cable](https://dl.dell.com/topics/inspiron-5402-service-manual/images/GUID-DF5B7186-8B95-4FA7-8D54-1FAA9F6199E2-low.jpg)
![Image: Removing the display assembly](https://dl.dell.com/topics/inspiron-5402-service-manual/images/GUID-AC66F4C2-4A43-4D24-932F-3FF0A1DB4123-low.jpg)
Steps
- Peel the tape that secures the display cable to the system board.
- Open the latch, and then disconnect the display cable from the system board.
- Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
- Remove the four screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
- Lift the left and right display hinges.
- Slide the palm-rest and keyboard assembly off the display assembly.
- After performing the above steps, you are left with the display assembly.
Data is not available for the Topic