Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
Steps
- Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
- Replace the two (M2x2) screws and adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
- Adhere the tape to secure the touchpad to the palm-rest and keyboard assembly.
- Align and place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
- Replace the three (M1.6x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
- Connect the touchpad cable to the system board and close the latch.
Data is not available for the Topic