Installing the speakers (in 4-cell battery configuration)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
![Image: Installing the speakers](https://dl.dell.com/topics//inspiron-14-5401-service-manual/images/GUID-A8B6BD9D-931A-49A2-B5C6-1758E850DDC9-low.jpg)
Steps
- Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
NOTE: If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place before replacing the speakers.
- Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
- Connect the speaker cable to the system board.
- Connect the keyboard-backlight cable and the keyboard cable to the system board.
Data is not available for the Topic