Installing the system fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system fan and provides a visual representation of the installation procedure.
Steps
- Align and place the fan on the palm-rest and keyboard assembly.
- Replace the two screws that secure the fan to the palm-rest and keyboard assembly.
- Route the I/O-board cable through the routing guides on the fan.
- Connect the fan cable to the system board.
- Connect the I/O-board cable to the system board and close the latch.
- Adhere the tape that secures the I/O-board cable to the system board.
- Adhere the mylar that covers the fan cable.
Data is not available for the Topic