Installing the power button with optional fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button with optional fingerprint reader and provides a visual representation of the installation procedure.
Steps
Align and place the power button on the palm-rest and keyboard assembly.
Adhere the fingerprint-reader board (optional) and the power-button cable on the palm-rest and keyboard assembly.
Replace the two screws (M2x2.5) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
Align and place the power-button bracket on the power button.
Replace the screw (M2x2) that secures the power-button bracket to the palm-rest and keyboard assembly.