Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Inspiron 5400 2n1 Service Manual

PDF

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the display assembly and provides a visual representation of the installation procedure.

Image: Installing the display assembly

Image: Installing the display assembly

Steps

  1. Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
  2. Replace the two screws (M2.5x5) that secure the left-display hinge to the palm-rest and keyboard assembly.
  3. Replace the three screws (M2.5x5) that secure the right-display hinge to the palm-rest and keyboard assembly.
  4. Connect the display-cable connector to the system board and close the latch to secure the cable.
  5. Adhere the tape that secures the display cable to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\