Procedure
- Align the screw hole on the system board with the screw hole on the
palm-rest and keyboard assembly.
- Replace the
screw (M2x4) that secures the system board to the palm rest and keyboard
assembly.
- Connect the power-adapter port cable and speaker cable to the system
board.
- Slide the power-button board cable into the connector on the system
board and close the latch to secure the cable.
- Slide the finger-print reader cable into the connector on the system
board and close the latch to secure the cable.
NOTE: : For computers shipped with finger-print reader only.
- Slide the I/O-board cable into the connector on the system
board and close the latch to secure the cable.
- Slide the hard-drive cable into the connector on the system
board and close the latch to secure the cable.
- Slide the touchpad cable into the connector on the system
board and close the latch to secure the cable.
- Slide the keyboard back-light cable into the connector on the system
board and close the latch to secure the cable.
- Slide the keyboard cable into the connector on the system
board and close the latch to secure the cable.
- Connect the speaker cable to the system board.
Data is not available for the Topic