Integrated Dell Remote Access Controller 9 User's Guide

Choosing operation mode using web interface

1. You can select the operation mode on when you are on any of the following pages:
   • Storage > Physical Disks .
   • Storage > Virtual Disks
   • Storage > Controllers
   • Storage > Enclosures
2. Select one of the following from the Apply Operation Mode drop-down menu:
   • Apply Now — Select this option to apply the settings immediately. This option is available for PERC 9 controllers only. If there are jobs to be completed, then this option is grayed-out. This job take at least 2 minutes to complete.
   • At Next Reboot — Select this option to apply the settings during the next system reboot.
   • At Scheduled Time — Select this option to apply the settings at a scheduled day and time:
     • Start Time and End Time — Click the calendar icons and select the days. From the drop-down menus, select the time. The settings are applied between the start time and end time.
     • From the drop-down menu, select the type of reboot:
       • No Reboot (Manually Reboot System)
       • Graceful Shutdown
       • Force Shutdown
       • Power Cycle System (cold boot)
   • Add to Pending Operations — Select this option to create a pending operation to apply the settings. You can view all pending operations for a controller in the Storage > Overview > Pending Operations page.

   NOTE:

   • The Add to Pending Operations option in not applicable for the Pending Operations page and for PCIe SSDs in the Physical Disks > Setup page.
   • Only the Apply Now option is available on the Enclosure Setup page.
3. Click Apply.
   Based on the operation mode selected, the settings are applied.