CAUTION:For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin can reduce the heat transfer capability of the thermal grease.
NOTE:The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you touch it.
NOTE:The system board can be removed as an assembly with the memory modules, fan and heat-sink assembly, ethernet and audio board, and USB board attached.
NOTE:This procedure only applies to computers shipped with a NVIDIA GeForce 3050 Ti graphics card.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the removal procedure.
Steps
Turn the system-board assembly over.
In sequential order (1>2>3>4>5>6), remove the six screws (M2x4) that secure the fan and heat-sink assembly to the system-board assembly.
Lift the fan and heat-sink assembly off the system-board assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\