Removing the display assembly
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
![Image: Display assembly](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-A857434C-7AA0-4F48-8F53-E63BB9E6B588-low.jpg)
![Image: Display assembly](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-F9823B05-366B-4504-8A2A-A3E57FA28A18-low.jpg)
Steps
- Peel that tape that secures the display-cable latch to the system board.
- Open the latch and disconnect the display cable from the system board.
- Disconnect the DDS (Dynamic Display Switch) cable from the system board.
- Turn the computer over and place the computer on a clean and flat surface.
- Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
- Remove the eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
Data is not available for the Topic