Installing the rear cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear cover and provides a visual representation of the installation procedure.
![Image: Replacing the rear cover](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-550157C5-63E3-44A1-A33A-7F51B32749FE-low.jpg)
Steps
- Slide the rear cover towards the system board till it snaps into place.
- Align the screw holes on the rear cover with the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2.5x5) that secure the rear cover to the palm-rest and keyboard assembly.
- Replace the two screws (M2x2) that secure the rear cover to the system board.
Data is not available for the Topic