Dell G16 7620 Service Manual

Installing the speakers

About this task

The following image indicates the location of the speakers and provides a visual representation of the installation procedure.

1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly
   NOTE:If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place before replacing the speakers.
2. Connect the speaker cable to the system board and route the cable below the ethernet and audio board.
3. Adhere the speaker cable to the palm-rest and keyboard assembly.
4. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
   NOTE:Route the speaker cable below the ethernet and audio. Do not route the speaker cable over the solid-state drive bracket.