Installing the keyboard-controller board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the keyboard-controller board and provides a visual representation of the installation procedure.
![Installing the keyboard-controller board](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-03730E86-E483-49EA-A7F8-48E5D7D1512E-low.jpg)
Steps
- Using the alignment posts, place the keyboard-controller board into the slot on the palm-rest and keyboard assembly.
- Replace the screw (M2x2) that secures the keyboard-controller board to the palm-rest and keyboard assembly.
- Connect the keyboard-controller board cable to the system board and close the latch.
- Connect the keyboard-backlight cable to the keyboard-contoller board and close the latch.
- Connect the keyboard cable to the keyboard-controller board and close the latch.
Data is not available for the Topic