Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell G16 7620 Service Manual

PDF

Installing the fan and heat-sink assembly (NVIDIA GeForce RTX 3050 Ti graphics card)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE:This procedure only applies to computers shipped with a NVIDIA GeForce 3050 Ti graphics card.

About this task

The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.

NOTE:If either the system board or the heat sink is replaced, use the thermal pad that is provided in the kit to ensure that thermal conductivity is achieved.
Image: Installing the fan and heat-sink assembly

Steps

  1. Place the fan and heat-sink assembly on the system board and align the screw holes on the fan and heat-sink assembly with the screw holes on the system board.
  2. In reverse sequential order (6>5>4>3>2>1), replace the six screws (M2x4) that secure the fan and heat-sink assembly to the system board.
  3. Turn the system-board assembly over.

Next steps

  1. Install the system board.
  2. Install the wireless card.
  3. Install the solid-state drive.
  4. Install the rear cover.
  5. Install the battery.
  6. Install the base cover.
  7. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\