Installing the ethernet and audio board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the installation procedure.
![Image: Installing the I/O board](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-01A1F984-D8F1-4891-8F6A-7C013792FEF9-low.jpg)
Steps
- Slide the ethernet and audio board into the M.2 card slot on the system board.
- Align the screw holes on the ethernet and audio board to the screw holes on the system board.
- Replace the two screws (M2x4) that secure the ethernet and audio board to the system board.
- Turn the system-board assembly over.
Data is not available for the Topic