Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
![Image: Installing base cover](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-EF59A1EC-0323-40F1-8194-1F02F41FC8DE-low.jpg)
![Image: Installing base cover](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-0D657CB0-237F-44CE-A798-2AD7C427EC2D-low.jpg)
![Image: Installing base cover](https://dl.dell.com/content/guides/public/Html/dell-g16-7620-service-manual/images/GUID-A4EBA739-CB8C-49A6-ACDD-4B21BEEDA57F-low.jpg)
Steps
- Connect the battery cable to the system board, if the battery cable had been previously disconnected.
- Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place.
- Replace the four screws (M2x6) that secure the base cover to the palm-rest and keyboard assembly.
- Tighten the four captive screws that secure the base cover to the palm-rest and keyboard assembly.
Data is not available for the Topic