CAUTION:For maximum cooling of the processor, do not touch the heat-transfer areas on the heat sink. The oils in your skin can reduce the heat-transfer capability of the thermal grease.
NOTE:The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you touch it.
NOTE:The system board can be removed as an assembly with the memory modules, fan and heat-sink assembly, Ethernet and audio board, and USB board attached.
NOTE:This procedure only applies to computers shipped with NVIDIA GeForce 3060/3070/3070 Ti graphics.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the removal procedure.
Steps
Turn the system-board assembly over.
In sequential order (1>2>3>4>5>6), remove the six screws (M2x4) that secure the fan and heat-sink assembly to the system-board assembly.
Lift the fan and heat-sink assembly off the system-board assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\