Removing the display assembly
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
![Image: Display assembly](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-A51867E3-F41C-462E-BE61-5F7D5DD7CDA5-low.jpg)
![Image: Installing the display assembly](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-0C855BCE-4821-4EE0-8104-CFBC2930643C-low.jpg)
Steps
- Peel the tapes that secure the antenna cables to the system board.
- Note the routing of the antenna cable and display cable, and remove the antenna cables from the left fan.
- Peel the tape and open the latch, and disconnect the display cable from the system board.
- Disconnect the camera cable from the system board.
- Flip the computer over and place the computer on a clean and flat surface.
- Remove the antenna cable and display cable from the routing guides on the palm-rest and keyboard assembly.
- Remove the eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
- Lift the hinges from the palm-rest and keyboard assembly.
- Slide and lift the display assembly off the palmrest and keyboard assembly.
- After performing all the above steps, you are left with the display assembly.
Data is not available for the Topic