Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.
![Image: Installing the I/O board](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-95967837-1AAA-4A80-BB1B-2E76723FDD31-low.jpg)
Steps
- Insert the I/O board at a 45 degree angle into the slot on the system board.
- Align the screw holes on the I/O board with the screw holes on the system board.
- Install the two screws (M2x4) that secure the I/O board to the system board.
Data is not available for the Topic