If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.
CAUTION:Incorrect
alignment of the heat sink can damage the system board and processor.
NOTE:If either the system board or the heat sink is
replaced, use the thermal pad/paste provided in the kit to ensure that thermal
conductivity is achieved.
Steps
Place the fan and heat-sink assembly on the system board and align the screw holes on the fan and heat-sink assembly with the screw holes on the system board.
Replace the six screws (M2x4) that secure the fan and heat-sink assembly to the system board.
Turn the system board over and align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.