Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
![Image: Installing base cover](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-10279D16-7A1E-47EA-A21B-E3210176F285-low.jpg)
![Image: Installing base cover](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-E4592DB0-F535-4DA5-AAD9-B4491E90D719-low.jpg)
![Image: Installing base cover](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-6A1717E9-FC17-412C-B90F-A3184A910710-low.jpg)
Steps
- Connect the battery cable to the system board, if the battery cable had been previously disconnected.
- Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place.
- Replace the four screws (M2x6) that secure the base cover to the palm-rest and keyboard assembly.
- Tighten the four captive screws that secure the base cover to the palm-rest and keyboard assembly.
Data is not available for the Topic