Installing the USB board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the USB board and provides a visual representation of the installation procedure.
![Image: Installing the USB board](https://dl.dell.com/content/guides/public/Html/dell-g15-5520-service-manual/images/GUID-D708CD60-2D9A-4989-892E-344C4ACF6E50-low.jpg)
Steps
- Align the screw holes on the USB board with the screw holes on the system board and insert the USB board in to the system board.
- Replace the two screws (M2x4) that secure the USB board to the system board.
Data is not available for the Topic