- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Network Attached Storage Overview
- Managing Assets and Protection
- About NAS protection
- Enable the NAS asset source
- Add a NAS appliance
- Add a NAS share
- Edit or delete a NAS asset source
- Deploy a protection engine for NAS asset protection
- Add a centralized protection policy for NAS assets
- Restore a NAS asset to the original location
- Restore a NAS asset to an alternate location
- NAS file level restore using File Search
- Protection engine parameters
- Determine protection engine usage for a protection job
- Change the protection engine Docker network range
- Troubleshooting
PowerProtect Data Manager 19.9 Network Attached Storage User Guide
Supported Internet Protocol versions
PowerProtect Data Manager only supports the use of IPv4 addresses.
Using an IPv6 address can result in errors or other unexpected behavior. When configuring devices to connect over the network with PowerProtect Data Manager, use only IPv4 addresses.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\