- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for File System Agent Overview
- Enabling the File System Agent
- About the File System agent
- Application agent and File System agent coexistence
- File System agent prerequisites
- File System agent limitations
- Block-based backups
- Best practices for file system backups
- Configure the file system parallel backup setting
- Configure asset multi-streaming for file-based backups
- Roadmap for protection with the File System agent
- Installing and updating the File System agent on Linux
- Installing and updating the File System agent on Windows
- Manage the PowerProtect agent service
- Managing Storage, Assets, and Protection
- Manage the File System agent
- Add protection storage
- Enable an asset source
- Delete an asset source
- Discover a file system host
- Adding a protection policy for File System protection
- Cancel a File System agent backup or restore job
- Add a Service Level Agreement
- Extended retention
- Edit the retention period for backup copies
- Delete backup copies
- Exclusion filters
- Centralized restore of a file system asset
- Troubleshooting File System agent backups
- Performing Self-Service Backup and Restore of the File System Agent
PowerProtect Data Manager 19.9 File System Agent User Guide
Troubleshooting File System agent backups
Issue
On Linux, the block-based incremental backups consistently fail and display a message similar to save: Block Based Error subsystem error while performing Block Based Backup.
Check if any other process is already accessing the snapshot, or delete the snapshot manually, and then try again.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\