Installing the
display assembly
- Place the display assembly to align with the screw holders on the
computer.
- Tighten the M1.6xL2 screws to secure the display assembly to the
computer.
- Turn over the computer.
- Connect the display cable to the connector.
- Place the metal bracket over the display connector
and tighten the screw to secure the display cable to the computer.
- Replace the power port on the system board
and tighten the screw to secure it to the display hinge.
- Route the WLAN card cable to its routing guide
on the fan and then reconnect the antenna cables to the WLAN card.
- Connect the eDP cable to its connector on
the system board.
- Install the:
- battery
- base cover
- microSD card
- Follow the procedure in After working inside
your computer
Data is not available for the Topic