Removing the
display assembly Follow the procedure in Before working inside
your computer . CAUTION The touch LCD Assembly is pre-assembled with the LCD
bezel, touch sensor daughter board, touch sensor cable, display cable,
and the camera module and hence cannot be further torn down and must
be replaced as an assembly.
Remove the: microSD card base cover battery Then: Disconnect the eDP cable [1]. Disconnect the antenna cables from the WLAN
card [2]. Unroute the WLAN cable from the its routing
guide on the fan [3]. Remove the M1.6xL2 screw securing the power
port to the display hinge [4]. Remove the power port from the system board
[5]. Then, do the following to remove the display: Remove the M1.6xL2 screw securing the metal
bracket covering the display cable connector [1]. Remove the metal bracket off the computer
[2]. Disconnect the display cable from its connector
on the system board [3]. Flip over the computer [4]. Remove the M2xL4 screws [1] and lift the display
assembly off the computer [2].
Data is not available for the Topic