Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure.
Steps
- Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
NOTE:Turn the computer over and open the display. Ensure that the touchpad is equally aligned along all four sides.
- Replace the eight screws (M1.6x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
- Slide the touchpad cable into its connector on the touchpad and close the latch to secure the cable.
- Fold down the keyboard-controller board cable.
- Slide the keyboard-controller board cable into the connector on the keyboard-controller board and close the latch to secure the cable.
Data is not available for the Topic