The following image(s) indicate the location of the speakers and provides a visual representation of the removal procedure.
Steps
Using a plastic scribe, disconnect the speaker cable from the system board.
NOTE:Some speaker connector might have the loop cable. If your speaker connector has a loop cable, do not pull the loop cable. To disconnect the speaker cable, grasp on the (acetic) black tape and lift up the cable.
Peel the tape that secures the speaker cable to the palm-rest and keyboard assembly.
Remove the speaker cables from the routing guides on the palm-rest and keyboard assembly.
Lift the right and left speakers, along with its cable, off the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\