If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.
Steps
Using the alignment posts, place the battery on the palm-rest and keyboard assembly.
Route the battery cable through the routing guides on the battery.
NOTE:The battery cable must be routed underneath the tab to the left of the battery cable connector and then into the channels above the top-left corner and to the left of the battery.
Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
Replace the six screws (M2x4) that secure the battery to the palm-rest and keyboard assembly.