Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.
NOTE:If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place before replacing the speakers.
Steps
- Using the alignment posts, place the left and right speakers into their slots on the palm-rest and keyboard assembly.
- Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
- Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly.
- Connect the speaker cable to the system board.
Data is not available for the Topic