If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure.
Steps
Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
NOTE:Turn the computer over and open the display. Ensure that the touchpad is equally aligned along all four sides.
Replace the three screws (M1.6x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
Replace the five screws (M1.6x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
NOTE:The five silver screws (M1.6x1.8) with larger heads indicated in red need to be secured along the top side of the touchpad while the three black screws (M1.6x1.8) with smaller heads need to be secured along the bottom side.
Fold down the keyboard cable.
Slide the touchpad cable into the connector on the keyboard-controller board and close the latch to secure the cable.
Slide the keyboard cable into the connector on the keyboard-controller board and close the latch to secure the cable.