NOTE:The display assembly is a Hinge-Up Display (HUD) and cannot be further disassembled.
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal procedure.
Steps
Remove the two screws (M1.6x1.8) that secure the display-cable bracket to the system board.
Lift the display-cable bracket off the system board.
Disconnect the display cable from the system board.
Turn the computer over.
Remove the four screws (M2x4) that secure the display-cable holder to the palm-rest and keyboard assembly.
Rotate the display-cable holder to 180 degrees.
Remove the display cable from the display-cable holder and lift the display-cable holder off the palm-rest and keyboard assembly.
NOTE:While removing the display cable from the display cable holder, push open the spring-loaded bar separating the two slits in the middle of the display holder.
Remove the six screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
Slide the display cable from the slot between the palm-rest and keyboard assembly and rear I/O cover.
Slide the display assembly off the palm-rest and keyboard assembly.
After performing the steps above, you are left with the display assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\