Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure.
Steps
- Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
- Turn the computer over and open the display to ensure that the touchpad is equally aligned on all sides.
NOTE:The image below shows the proper touchpad alignment for your computer.
- Close the display and turn the computer over.
- Replace the four screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
- Connect the keyboard-controller board cable the system board and close the latch to secure the cable.
- Connect the touchpad cable to the system board and close the latch to secure the cable.
- Align and place the touchpad bracket into slots on the palm-rest and keyboard assembly.
- Replace the four screws (M2x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
- Adhere the tape back on touchpad bracket screw.
Data is not available for the Topic