NOTE:The system board can be removed and installed along with the audio board, small fan, and heat sink-assembly. This simplifies the removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink.
About this task
The following image(s) indicate the location of the power button and provides a visual representation of the removal procedure.
Steps
Open the latch and disconnect the power-button cable from the palm-rest and keyboard assembly.
Remove the two screws (M2x3) that secure the power-button bracket to the palm-rest and keyboard assembly.
Peel the tapes securing the power-button bracket to the palm-rest and keyboard assembly.
Lift the power-button bracket off the power button.
Peel the tape securing the power button to the palm-rest and keyboard assembly.
Lift the power button, along with its cable, off the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\