- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m18 R1
- Base cover
- Solid-state drive
- Removing the M.2 2230 solid-state drive in slot three and slot four
- Installing the M.2 2230 solid-state drive in slot three and slot four
- Removing the M.2 2280 solid-state drive in slot one and slot two
- Installing the M.2 2280 solid-state drive in slot one and slot two
- Procedure to move the screw mount in SSD slot one and two
- Memory
- Wireless card
- Fan
- Rear-I/O cover
- WLAN board
- Battery
- Speakers
- Power-adapter port
- Touchpad
- Antennas
- Display assembly
- Top heat-sink
- Keyboard-controller board
- System board
- Heat-sink assembly
- Audio board
- USB Type-C board
- Power button
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- System-diagnostic lights
- SupportAssist diagnostics
- Built-in self-test (BIST)
- Recovering the operating system
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Backup media and recovery options
- Getting help and contacting Alienware
Alienware m18 R1 Service Manual
Removing the power-adapter port
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the rear-I/O cover.
- Remove the top heat-sink.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal procedure.
Steps
- Peel the tape that secures the display-cable connector latch to the system board.
- Open the latch and disconnect the display cable from the system board.
- Peel the display cable off the system board and remove the display cable from the slot on the palm-rest and keyboard assembly.
- Remove the two screws (M2x3) that secure the power-adapter port-bracket to the palm-rest and keyboard assembly.
- Lift the power-adapter port bracket off the palm-rest and keyboard assembly.
- Disconnect the power-adapter port-cable from the system board.
- Peel the power-adapter port-cable from the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\