NOTE:The system board can be removed and installed along with the heat sink. This simplifies the removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
Steps
Peel the tape securing the I/O board cable to the palm-rest and keyboard assembly.
Open the latch and disconnect the I/O board cable from the palm-rest and keyboard assembly.
Open the latch and disconnect the power-button cable from the palm-rest and keyboard assembly.
Remove the four screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
Lift the I/O board off the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\