Alienware m18 R1 Service Manual

Installing the memory module

If you are replacing a component, remove the existing component before performing the installation process.

NOTE:Up to two memory modules may be installed into this computer.

The following image(s) indicate the location of the memory module and provides a visual representation of the installation procedure.

Image: Installing the memory module

Lift the Mylar to access the memory slot.
Align the notch on the memory with the tab on the memory slot.
CAUTION:To prevent damage to the memory module, hold the memory module by the edges. Do not touch the components or metallic contacts on the memory module as ESD can inflict severe damage on the components. To read more about ESD protection click here.
Slide the memory module firmly at an angle, into the memory-module slot.
Press the memory module down until it clicks into place.
NOTE:Repeat the steps to install any other memory module into your computer.
NOTE:The securing clips return to a locked position. If you do not hear the click, remove the memory module and reinstall it.