- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m17 R5 AMD
- Base cover
- Solid-state drive
- Removing the M.2 2230 solid-state drive in slot one
- Installing the M.2 2230 solid-state drive in slot one
- Removing the M.2 2280 solid-state drive in slot one
- Installing the M.2 2280 solid-state drive in slot one
- Procedure to move the screw mount in SSD slot one
- Removing the M.2 2230 solid-state drive in slot two
- Installing the M.2 2230 solid-state drive in slot two
- Removing the M.2 2280 solid-state drive in slot two
- Installing the M.2 2280 solid-state drive in slot two
- Procedure to move the screw mount in SSD slot two
- Memory module
- Wireless card
- Rear-I/O cover
- Battery
- Battery cable
- Speakers
- Power-adapter port
- Touchpad
- Display assembly
- Keyboard-controller board
- System board
- Fan and heat-sink assembly
- Ethernet and audio board
- USB board
- Power button
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- System-diagnostic lights
- SupportAssist diagnostics
- Built-in self-test (BIST)
- Recovering the operating system
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Backup media and recovery options
- Getting help and contacting Alienware
Alienware m17 R5 AMD Service Manual
Installing the M.2 2280 solid-state drive in slot one
Prerequisites
About this task
NOTE:This procedure is applicable if you are installing a M.2 2280 solid-state drive into M.2 slot one (SSD1).
NOTE:Supported card configurations on M.2 slot one (SSD1):
- M.2 2230 solid-state drive
- M.2 2280 solid-state drive
NOTE:This procedure is applicable only to computers shipped with NVIDIA GeForce RTX 3050 Ti graphics card.
The following image(s) indicate the location of the M.2 2280 solid-state drive in slot one and provides a visual representation of the installation procedure.
Steps
- Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot on the system board.
- Slide the M.2 2280 solid-state drive into the M.2 card slot on the system board.
- Slide the tab on the M.2 2280 thermal shield into the M.2 card slot and align the screw holes on the thermal shield to the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2x4) that secure the M.2 2280 thermal shield to the palm-rest and keyboard assembly.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\