Installing the rear-I/O cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the rear-I/O cover and provides a visual representation of the installation procedure.
![Image: Installing the rear-I/O cover](https://dl.dell.com/content/guides/public/Html/alienware-m17-ryzen-edition-r5-service-manual/images/GUID-A4F88CD6-A112-4CA2-8794-8679075B511D-low.jpg)
Steps
- With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place.
NOTE:To avoiding damaging your computer, ensure the Tron-light cable is not pinched before snapping the rear I/O-cover into place.
- Replace the three screws (M2x3) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
- Replace the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
- Connect the Tron-light cable to the system board.
Data is not available for the Topic