- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m17 R5 AMD
- Base cover
- Solid-state drive
- Removing the M.2 2230 solid-state drive in slot one
- Installing the M.2 2230 solid-state drive in slot one
- Removing the M.2 2280 solid-state drive in slot one
- Installing the M.2 2280 solid-state drive in slot one
- Procedure to move the screw mount in SSD slot one
- Removing the M.2 2230 solid-state drive in slot two
- Installing the M.2 2230 solid-state drive in slot two
- Removing the M.2 2280 solid-state drive in slot two
- Installing the M.2 2280 solid-state drive in slot two
- Procedure to move the screw mount in SSD slot two
- Memory module
- Wireless card
- Rear-I/O cover
- Battery
- Battery cable
- Speakers
- Power-adapter port
- Touchpad
- Display assembly
- Keyboard-controller board
- System board
- Fan and heat-sink assembly
- Ethernet and audio board
- USB board
- Power button
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- System-diagnostic lights
- SupportAssist diagnostics
- Built-in self-test (BIST)
- Recovering the operating system
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Backup media and recovery options
- Getting help and contacting Alienware
Alienware m17 R5 AMD Service Manual
Installing the keyboard-controller board
Prerequisites
About this task
The following image(s) indicate the location of the keyboard-controller board and provides a visual representation of the installation procedure.
Steps
- Connect the keyboard-controller board cable to the keyboard-controller board and close the latch to secure the cable.
- Using the alignment posts, place the keyboard-controller board into the slot on the palm-rest and keyboard assembly.
- Replace the screw (M2x2) that secures the keyboard-controller board to the palm-rest and keyboard assembly.
- Connect the keyboard cable to the keyboard-controller board and close the latch to secure the cable.
- Connect the keyboard-backlight cable to the keyboard-controller board and close the latch to secure the cable.
- Adhere the Mylar on to the keyboard-controller board.
Next steps
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\