Installing the fan and heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.
![Installing the fan and heat-sink assembly](https://dl.dell.com/content/guides/public/Html/alienware-m17-ryzen-edition-r5-service-manual/images/GUID-D9DAA775-7A97-4519-BDC3-1472B9C3C048-low.jpg)
Steps
- Place the fan and heat-sink assembly on the system board.
- Align the screw holes on the fan and heat-sink assembly to the screw holes on the system board.
- In sequential order (1>2>3>4>5>6>), tighten the six captive screws (M2x4) that secure the fan and heat-sink assembly to the system board.
- Turn over the system-board assembly.
Data is not available for the Topic