Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure.
![Image: Installing the display assembly1](https://dl.dell.com/content/guides/public/Html/alienware-m17-ryzen-edition-r5-service-manual/images/GUID-80EF7D38-5A74-4DBE-84DF-0CFC59F6D515-low.jpg)
![Image: Installing the display assembly2](https://dl.dell.com/content/guides/public/Html/alienware-m17-ryzen-edition-r5-service-manual/images/GUID-77D25879-5D54-4B52-8A95-7C2FCB7810AC-low.jpg)
Steps
- Place the display assembly on the palm-rest and keyboard assembly.
CAUTION:To avoid damaging the display, do not slide display assembly over the palm-rest and keyboard assembly.
- Align the screw holes on the display assembly with the screw holes on the palm-rest and keyboard assembly.
- Replace the six screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
- Route the display cable and Alien head LED-cable through the routing guides on the display assembly.
- Turn over the computer.
- Route the display cable through the slot on the palm-rest and keyboard assembly.
- Connect the Alien head LED-cable to the system board.
- Adhere the display cable to the system board.
- Connect the display cable to the system board and close the latch to secure the cable.
- Adhere the tape that secures the display-cable connector latch to the system board.
- Adhere the tapes that secure the camera cable to the system board.
- Route the camera cable through the slot on the palm-rest and keyboard assembly.
- Route the camera cable through the routing guides on the palm-rest and keyboard assembly and fan.
- Connect the camera cable to the system board.
Data is not available for the Topic