Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the base cover and provides a visual representation of the installation procedure.
Steps
- Connect the battery cable to the system board.
- Adhere the tape that secures the battery cable to the battery.
- Slide the tabs on the top of the base cover under the rear I/O-cover and snap the base cover to the palm-rest and keyboard assembly.
- Tighten the two captive screws (M2.5x6) on the base cover that secure the base cover to the palm-rest and keyboard assembly.
- Tighten the two captive screws (M2.5x14) on the base cover that secure the base cover to the palm-rest and keyboard assembly.
- Replace the four screws (M2.5x5) that secure the base cover to the palm-rest and keyboard assembly.
Data is not available for the Topic