NOTE:The system board can be removed and installed along with the memory, audio board, and fan and heat sink-assembly. This simplifies the removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink.
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.
Steps
After performing the pre-requisites you are left with the palm-rest and keyboard assembly.
NOTE:Ensure that the solid-state drive mounts on slot one and two are removed from the old palm-rest and keyboard assembly before installing the new palm-rest and keyboard assembly. These solid-state drive mounts will be installed into the new palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\