Removing the display assembly
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal procedure.
Steps
- Peel the tape securing the camera cable to the system board.
- Disconnect the camera cable from the system board.
- Disconnect the display cable from the system board.
- Peel the tapes securing the display cable to the system board and lift the display cable off the system board.
- Turn the computer over.
- Remove the four screws (M2.5x5) that secure the antenna holder to the palm-rest and keyboard assembly.
- Remove the six screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
- Lift the display assembly off the palm-rest and keyboard assembly.
Data is not available for the Topic