Installing the rear-I/O cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the rear-I/O cover and provides a visual representation of the installation procedure.
Steps
- With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place.
- Replace the five screws (M2x4) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
- Connect the Tron-light cable to the system board.
- Replace the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
Data is not available for the Topic