Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
- Slide the power-adapter port at an angle into the slot on the palm-rest and keyboard assembly and adhere the power-adapter port cable to the Mylar.
- Connect the power-adapter port cable to the system board.
- Place the power-adapter port bracket on the power-adapter port.
- Align the screw holes on the power-adapter port bracket to the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2x4) that secure the power-adapter port bracket to the palm-rest and keyboard assembly.
- Adhere the display cable to the system board.
- Connect the display cable to the system board and close the latch to secure the cable.
- Adhere the tape that secures the display-cable connector latch to the system board.
Data is not available for the Topic