Installing the USB board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the USB board and provides a visual representation of the installation procedure.
![Installing the USB board](https://dl.dell.com/content/guides/public/Html/alienware-m15-r7-service-manual/images/GUID-DB702F8C-8293-45BE-9320-B10127E59C17-low.jpg)
Steps
- Connect the USB board to the system-board assembly.
- Align the screw holes on the USB board to the screw holes on the system-board assembly.
- Replace the three screws (M2x4) that secure the USB board to the system-board assembly.
- Turn the system-board assembly over.
Data is not available for the Topic